Special characteristics of wall design
DOI:
https://doi.org/10.3989/ic.1988.v40.i398.1570Abstract
This paper deals about the difference between designing some parts of the retaining walls, multiplicand the actual loads and active confinement pressures by the appropiate load factors (the correct and mandatory method) and the obtaining the bearing pressures, and the design of those parts working with the bearing pressures obtained multiplicand the bearing pressures under service load conditions, by the load factor. The study shows the important difference between the results obtained by means of the two methods.
Downloads
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 1988 Consejo Superior de Investigaciones Científicas (CSIC)
This work is licensed under a Creative Commons Attribution 4.0 International License.
© CSIC. Manuscripts published in both the print and online versions of this journal are the property of the Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.
All contents of this electronic edition, except where otherwise noted, are distributed under a Creative Commons Attribution 4.0 International (CC BY 4.0) licence. You may read the basic information and the legal text of the licence. The indication of the CC BY 4.0 licence must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the final version of the work produced by the publisher, is not allowed.
